焊工试题1（Welder test 1）.docVIP

焊工试题1（Welder test 1） Intermediate welder test Description: The point. According to the development trend of the test, we chose to fill in the blanks and judge two types of questions. Scope of knowledge 1) knowledge of metal materials and heat treatment Basic knowledge of welder electrician 3) welding arc and welding metallurgy knowledge 4) gas protection welding technology and equipment 5) other welding process technology and equipment Welding of metal materials 7) welding stress and deformation 8) welding defects and inspection 9) knowledge of relevant working knowledge The relevant intermediate test contains some preliminary work contents. Please pay attention Please pay attention to the changes of different questions or different ways of asking the same question Select the correct answer (select the correct answer and fill in the corresponding letter) The smallest geometric unit that can fully reflect the lattice features is called () A grain B crystal cell C crystal surface D crystal The purpose of () is to make the nucleus grow smaller A heat treatment B metamorphic treatment C cold treatment D strengthening treatment The same is true of a metal that occurs when the same isomeric transformation occurs A metal creep B metal reinforced C metal deformation D metal crystal 4. The change of metal in solid state with temperature, the phenomenon of transformation from one lattice to another is called (). A lattice transformation B crystal transformation C isomerization transformation of D isomorphism 5. The binary alloy phase diagrams are established through () methods A simulation B calculation C test D analysis 6. The formation of a solid solution in gamma Fe, which is soluble in the cubic lattice of the surface, is called () A ferrite B austenite C carburizing D lystenite The tissue formed in the gamma-fe of carbon is called austenite A metal crystal B compact cubic lattice C surface centred cubic lattice D body centred cubic lattice The cotectic line on the iron c