钢网制作技术规范（Technical specification for steel mesh fabrication）.doc

下载文档 降价啦

13
0
约1.38万字
约 25页
2017-08-04 发布于河南
举报
版权申诉
保障服务

钢网制作技术规范（Technical specification for steel mesh fabrication）.doc

1、本文档共25页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

钢网制作技术规范（Technical specification for steel mesh fabrication） Stencil manufacturing technical specification 2009-2-3 21:08:25 source: Author: click here: 705 times -------------------------------------------------------------------------------- Stencil manufacturing technical specification General: Mentioned in this specification of openings are considered pads for the rules, if there is irregular or pad with normal welding The disk size is quite different, as the case should be decided to open way. A screen frame. According to the customer use of printing machine corresponding specifications of the screen frame, there are several commonly used screen frame: 29X29inch 23X23inch 650X550mm The tension and the network two. The steel sheet surface roughening treatment and grinding edge of steel sheet with fine sandpaper, then stretch mesh according to customer requirements. Three pieces of steel. In order to ensure the steel mesh with sufficient tension and good flatness, the steel sheet from the inner side of the outer frame should be retained The distance of 25mm, the specific size of steel sheet in Appendix two aluminum frame specifications and steel sheet cutting size table.. build According to the different components on the steel sheet thickness corresponding to the minimum, mainly on the basis of opening and the minimum distance is considered heavy Both the other, see the table below or can be calculated according to the formula: If the pad size L 5W, according to the thickness ratio of steel sheet thickness calculation. T W / 1.5 If the pad is square or round, according to area ratio calculation of the steel sheet thickness. T (L * W) / 1.32X (LW) The element opening design and the corresponding steel sheet thickness gauge Part Type Pitch PAD Foot Print width PAD Foot Print Length Aperture Width Aperture Length Stencil Thickness Range PLCC 1.25-1.27mm 0.65mm 2.00mm 0.6mm 1.95mm 0.15-0.25mm 0.65mm 0.35mm 1.5mm 0.3mm 1.45MM 0.15-0.175mm 0.5mm 0.3mm 1.25mm 0.25mm