滴水线（drip line）.docVIP

滴水线（drip line） drip line edit In the window below the table will generally have a concave line, that is to prevent rain delay plate flow to the design in the wall, in the line outside the rain fall, this is the drip line, applicable to the construction of water blocking requirements of the site, the general drip line (tank) in the window lintel under the mouth, if the concrete surface is very smooth with texturing on the surface. Catalog 1 water line 2 water practices 3 Construction Technology 4 drop range Principle 5 water line 1 water line editor In the construction project in order to prevent the water from the stream in the end wall and side wall vertical design, groove shaped parts along the lower part of the structure is arranged around the drip line, called (also called Gargoyle). General settings in the awning, windows, stairs, balcony, parapet wall and top prominent waist and other parts. The general is at the junction of the bottom surface of the outer wall of the place, from the corner of 1-2cm, do a groove about 1cm wide, so the water can be cut off without inward flow. 2 drop editing practice 1, basic level processing: General drip line (tank) in the window lintel under the mouth, if the concrete surface is very smooth with texturing the surface: one is chisel, namely with chisel cutting, tick to smooth the rough. Another method is to scorch, which is on the surface of the concrete clean up by mechanical spraying or with a broom thrown on a layer of cement mortar (1:1 gruel shape with appropriate building glue) to dissolve in the concrete surface, with the hand not moving. 2, paste the drip line (tank): according to the elastic line of position well, by adding the adhesive mortar to the drip line (tank) paste, depending on the situation, about 50 ~ 80cm cloth a paste, less than 2m in 2 ~ 3 point window cloth, more than 2m of 3 ~ 5 point window cloth. 3, the drip line (tank) construction should be carried out simultaneously with the construction of outer