电伴热施工（Electric tracing construction）.doc

电伴热施工（Electric tracing construction） The document from the network, is my collection of finishing, if there are omissions, errors, please! Electric heating construction (a) design Before the construction should be a complete design Should include the following information map: 1, line number, represented by the plaid supply point 2, the required power line of tropical type and length (unit: m) 3 per meter, pipe length required cable length (unit: m) is winding coefficient 4, each valve required electricity zone length (unit: m) 5, with supporting materials, thermal system accessories list 6 temperature control system of parts list List of materials required for construction, 7 8, consider the design parameters and the thermal insulation material specifications (two) preparation work before construction (A) pipeline system 1, the pipeline system has been completed and are equipped with 2, anticorrosive coating has been dry In 3, consistent piping system construction specification and design drawing 4, to file all burrs and sharp angle (B) cables and accessories 1, whether the tropical surface is damaged 2, electric tropical good insulation properties (requirements of insulation resistance in 1000VDC test with the shaking table of no less than 20M Ohm) Consistent with the design requirements, type 3 cable with all accessories (C) site preparation 1, a roll of drum and placed in a cable bracket, and placed in the near end of line 2, the cloth along the pipe heater, and avoid: * will be placed in electric tropical burrs and sharp angle. * pull cable * foot or heavy objects on the cable (three) a single cable construction method 1, glass fiber adhesive tape or aluminum tape at intervals of about 50Cm will be fixed on the pipe heater 2, apply as much as possible will be attached to the tropical electric pipelines under 45 degree lateral In 3, the first power supply line and the end point of the reserved 1m long cable 4, according to the design shown in [] (coefficient coe