电工操作证试题七（Electrician operation certificate seven）.docVIP

电工操作证试题七（Electrician operation certificate seven） A single choice 1, work in the distribution of total disk and bus, installation of temporary grounding line should be (for). A, B, C, maintenance electrician, electrician on duty as the work of D, and no specific provisions 2, TN-C system in the work of the zero line and the protective zero line is () A, B, combined with C, part combination part of separate D, none of the above 3, in the explosion hazardous areas, should use steel wiring, the wall thickness is not less than (MM). A, 1 B, 1.5 C, 2 D, 2.5 4, when the transmission circuit phase short circuit, the current in the circuit () A, B, C increase suddenly decreased suddenly, constant D, none of the above 5, when the equipment grounding fault occurs, the step voltage value and voltage value (equipment) A, is proportional to B and inversely proportional to the C, D, none of the above. 6, () is a kind of protection, protection of the motor phase operation of the motor. A, B, C, short circuit overload, phase D, pressure loss 7, using the method of clamp ammeters measuring single-phase load current (is) A, a wire clamp jaw jaw clamp, B C, the two wire clamp meter in series with the load D, the clamp meter is in parallel with the load 8, the difference between the high voltage side of the transformer voltage and rated voltage should not exceed () A, 5% B, 10% C, 25% D, 15% 9, according to the rules of 220V line voltage loss is allowed () A, 22V B, 11V C, 20V D, 25V 10, a single-phase power supply circuit, voltage loss through calculation and verification, should not be less than the requirements of 3mm2 wire section, therefore should choose (mm2) wire A, 3 B, 4 C, 5 D, 6 11, for high voltage power transformers and other equipment, in addition to measure the insulation resistance, also requires the measurement of absorption ratio, absorption ratio (a) A, R15/R60 B, R60/R20 C, R60/R15 D, R60/R5 12, by the same transformer power supply by zero protection system, all met