焦化考试题11（Coking examination questions 11）.doc

焦化考试题11（Coking examination questions 11） Maintenance electrician test A choice (each of 2 points, a total of 40 points) (1) in electrical diagram, general circuit or element according to the function layout, and according to the work order (D) arrangement. A from the front to the back, from left to right; B from top to bottom, from front to back; C, from small to large; D from left to right, from top to bottom. (2) R1 R2, R3 resistance, series connected power supply, if the voltage on the relationship between resistance is U1 U3 U2, the three is the relationship between the resistance value (B). A R1 R2 R3 R3 B, R1 R2, C R1 R3 R2 R2 R3, D R1 (3) high speed motor bearings, grease or work should be selected cone penetration small viscosity (past called penetration) (A) grease. A B C D super large small. (4) is used to switch transformers (C). A adjust the impedance; B adjustment phase; C adjust the output voltage regulation level; D. (5) (A) motor three-phase AC asynchronous motor model. A Y-132S-4; B Z2-32; C SJL-500/10; D ZQ-32. (6) a DC motor model for ZQ-32, where Q (A) A traction motor; motor B ship; C general motors; D motor home. (7) the working principle of the intermediate relay (D) A is the chemical effect of current; B is the current thermal effect; C is the mechanical effect of current D with the same contactor. (8) the autotransformer voltage starting method is generally applicable to (A) of three-phase cage induction motor. A large capacity; B small capacity; C capacity is small; the capacity of various D. (9) insulation resistance shall not be less than the type of hand-held electric tool (B) M.A0.5; B1; C2; D7. (10) asynchronous motor with delta-y decompression startup, each phase stator windings to withstand voltage is delta connected full pressure startup times (C). A2; B3; C1/ * 3; D1/3. (11) the three elements refer to sinusoidal alternating current (D). The maximum A value, frequency and angle frequency; B RMS, frequency and angular freq