活塞环安装（Piston ring installation）.doc

活塞环安装（Piston ring installation） Some of the engine maintenance, the use of 300 ~ 500h, there is burning, oil discharge phenomenon. We improved through years of exploration, and achieved good results. The main reason, engine oil burning, row 1, cylinder liner, piston ring wear, the gap and gap of piston ring increases with the cylinder and the piston, poor sealing effect. 2, the poor quality of piston ring. The piston ring is made into the market most of the oil scraper ring rectangular ring, poor performance, which is one of the important factors of engine oil. 3, a piston ring opening near the opening or overlap, especially oil ring overlapping counterparts causing oil channeling, spillover. 4, do not pay attention to the air cleaner hand machine maintenance. We did the test, when entering the air in the cylinder dust containing 0.5g/m, 25 ~ 100h, 0.15 ~ 0.40mm increased wear of the cylinder. Thus, the air cleaner is good or bad, is one of the causes of the cylinder and the piston ring wear. In addition to our transformation of air filter and strengthen the usual maintenance, research and test key structure and assembly method of the piston ring. Two, the improvement of the structure of the piston ring second, third air ring and oil ring were processed, the method is: use semicircle file, along the second, third piston circle in the end, uniform filing into 1mm * 45 degree chamfer, make it become twisted ring chamfer, and the outer circle of the cast iron oil ring thin file 0.5mm * 45 degree chamfer, fillet and oil ring assembly when outer ring to chamfer. The two kind of twisted ring at work, can be a dish shaped distortion, the ring under the angle of tension is greater than the upper corner, with upward scraping function. Three, the assembly method in the actual assembly, we did not follow the three air ring opening of a 120 degree uniform distribution, and the lining ring opening is not installed by 180 degrees oil ring, but the three air ring opening was arran