Cell Phone Lockers 19000 Series（手机储物柜 19000系列）.pdf

Cell Phone Lockers - 19000 Series Surface Mounted Installation Instructions Installation of the Surface Mounted Enclosure Installing the Cell Phone Locker into the Enclosure Remove the locker unit from the enclosure. Drill mounting holes in Install the locker unit into the enclosure by sliding it into the enclosure the enclosure to fasten it to the mounting surface. It is important to until its front peripheral flange is flush against the front of the use at least four (4) fasteners (not provided) and place one each at enclosure. Open the four corner compartments of the cell phone the four (4) corners of the mounting surface (either on the rear panel locker. Install #8 x 1-1/4 in. long screws (provided) through the top or the bottom panel). Choose appropriate hardware for the particular and bottom of the locker unit into the enclosure. Close the conditions of the installation. compartment doors. SALSBURY INDUSTRIES nd 1010 East 62 Street, Los Angeles, CA 90001-1598 Phone: 1-800-624-5269 Int’l Phone: 323-846-6700 Fax: 1-800-624-5299 Int’l Fax: 323-846-6800 engineering@ engineering@ Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability. Copyright © 2014 Salsbur