General Logic Configuration (Config gt; General （一般逻辑配置(配置→一般）.pdfVIP

Many Mach 3 users are very confused about the CV settings and how they affect machine motion. Maybe I can shed some needed light on the topic :) General Logic Configuration (Config - General Config...) -Motion Mode (Constant Velocity OR Exact Stop) Constant Velocity “CV” – This mode attempts to maintain a constant velocity during ALL angular or arc moves while obeying the acceleration parameter. This is not possible during some moves...such as single axis moves that change direction (i.e. Motion must stop at some point during these moves). On moves where constant velocity can be