INSTALLATION, OPERATION MAINTENANCE （安装、操作和维护）.pdfVIP

COSASCO TWO-INCH SYSTEM INSTALLATION, OPERATION MAINTENANCE MANUAL HOT TAP Rohrback Cosasco Systems 11841 East Smith Ave. Santa Fe Springs, CA 90670 Tel: (1) 562-949-0123 Fax: (1) 562-949-3065 E-mail: rcs@ Web Site: P/N: 740078 rev. - Table of Contents Chapter 1 Introduction…1 Chapter 2 Hydrostatic Testing…………………………………2 Chapter 3 Operating Instructions …5 Chapter 4 Disassembly-Assembly (Hot Tap)…………………...9 Chapter 5 Care Maintenance……………………………….….13 1 Chapter 1 Introduction The Cosasco 2” Hot Tap was developed to provide a means of adding a Cosasco Access System to any pipeline or vessel already on stream – without shutdown or product loss. The Hot Tap is used in conjunction with any of the Cosasco Retrievers and Service Valves to enable both retrieval and installation under pressure. The Hot Tap Assembly has ample cutter travel to allow hot tapping through all standard access fitting lengths, and pipe wall thicknesses. The Hot Tap is conveniently packaged in a Kit which contains both spare parts and special tools. The Hot Tap cutter will trepan a hole that will allow free passage of any of the Cosasco probes and tools. The cutter will also retain the slug and minimize the chips dropped into the line. Two different tooth designs are provided in the Hot Tap Kit to cover both thin and heavy wall thicknesses. The Hot Tap Ball End Mill and Square Nose End Mill were developed to allow repair of undersized or obstructed pre-cut holes in order to obtain concentricity of the access fitting body bore and the trepanned hole. The 2” Hot Tap will operate in any position, and cut any grade of pipe or vessel wall