lONgTERM sORATgEPROTECTION Precision （长期sORATgEPROTECTION精度）.pdfVIP

READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION OPERATION MAINTENANCE lONg-TERM sTORAgE PROTECTION of mounted spherical roller bearings PROCEduRE fOR shOP AssEMblEd PIllOw blOCks 1. Properly mount the bearings on the shaft. 2. It is unnecessary to degrease the bearings if they are mounted immediately after unwrapping. If this is the case, proceed to step 5. If the bearings have been exposed for several hours between unwrapping and mounting, it will be necessary to remove the foreign matter by thoroughly washing out the bearings. 3. After being assured that the bearings are clean, swivel them open and apply a rust preventative solvent liberally to all surfaces. (Example: Ashland Oil Tectyl 511-M, or equivalent) 4. Swivel close the outer rings of the bearings into operating position and rotate them. For Spherical roller bearings, be careful not to use force in the event a roller end catches the corner of the outer ring sphere. A slight lifting of the roller will eliminate the catching of the roller end on the outer ring sphere. 5. Pack each bearing 100% full of grease is intended to lubricate the bearings during operation. 6. Inspect and clean the pillow block lower halves as needed. Set the lower halves of the pillow blocks at operating distance from each other and lower the shaft assembly with mounted bearings into pillow blocks. 7. Fill the cavity of the pillow blocks with the same grease as used in the bearings. Then mound up the grease around the bearing to simulate the shape of the inside of the upper half of the pillow blo