Moulds and dies Welcome to International （模具和模具,欢迎来到国际）.pdfVIP

Moulds and dies TOOLOX is a registered trademark by SSAB Oxelösund AB, Sweden Application areas • Plastic and rubber moulds. • Pressure die casting. • Sheet metal forming. • Ceramic moulds. Note; All application cases were controlled in January 2007. For a current update please contact respective contact person. Normally, the german W.Nr. designations have been used to describe the steels replaced. • The only tool steel available on the market as pre-hardened to 45 HRC. • Delivered with guaranteed properties. • ESR-properties for highest polishing demands. • Perfect to make prototypes and final mould in the same tool. • Excellent substrate for surface engineering, i.e. nitriding and PVD-coating. Plastic mould in TOOLOX 33 Function Experience Plastic mould for manufacture of a head- The mould was put into use in June 2005. light glass. Since the cover is transparent, Since then more than 100,000 pieces have the surface quality of the mould is very been made with fully satisfactorily result. important. The mould has two parts, one is seen in the photo to the right, the other in the upper left Contact person photo. Christer Offerman, SSAB Oxelösund. Plastic Polycarbonate (PC). Previous steel For the internal thicker part, W.Nr 1.2738 was used. For the thinner pieces, W.Nr 1.2311 was used. The customer had significant problems to obtain a good flatness of the thinner pieces. Manufacturing Blanks made of 250x12 mm TOOLOX 33 were used. The customer was very satisfied with the dimensional stability. A very good surface