Categories of surface roughness MISUMI USA（类别的表面粗糙度,三角美国）.pdf

’TECHNICAL DATA» SURFACE ROUGHNESS EXCERPT FROM JIS B 0601 (1994) AND JIS B 0031 (1994) Categories of surface roughness Definitions and indications for surface roughness parameters (for industrial products)are specified. They are arithmetical mean roughness (Ra), maximum height (Ry), ten-point mean roughness (Rz), mean spacing of profile irregularities (Sm), mean spacing of local peaks of theprofile (S)and profile bearing length ratio (tp). Surface roughness is given as the arithmetical mean value for a randomly sampled area. ’Mean center line roughness (Ra 75)is defined in the annexes of JIS B 0031 and JIS B 0601.» Typical ways for obtaining surface roughness 1 R Arithmetical mean roughness (Ra) (◊ ◊ Y Ra= R 0 f ) d m A section of standard length is sampled from the mean line on the roughness chart. The mean line is laid on a Cartesian coordinate system where in the mean line runs in the direction a R of the x-axis and magnification is the y-axis. The value 0 X obtained with the formula on the right is expressed in micrometer (Om)when y=f ◊ . ( )