欧洲法规介绍课件.pptVIP

INTERIOR FITTINGS内部突出物;SYNOPSIS 主题题要;European Regulation 欧洲法规简介;Interior fittings - ECE 21 ECE21 内部突出物;This regulation specifies requirements to afford impact protection for occupants It applies to interior fittings of passenger vehicles with maximum 9 seats relating to : the interior parts of the passenger compartment, the layout of controls, the roof, the rear parts of seats, the power-operation of windows, roof-panel and partition systems;Requirements applies to 4 interior zones and seats 适用于4个内部区域及座椅的要求;Level of the instrument panel 仪表板水平面线;Forward interior parts of the passenger compartment above the level of the instrument panel in front of the front seat H point In the reference zone : no dangerous roughness or sharp edges (radius above 2,5 mm) parts shall be energy-dissipating Switches and pull-knobs shall respect dimensionnal requirements (minimal cross sectionnal area, minimum radius, retraction under load depending on the height of the component) ; The requirements about the minimal value of radii of curvature do not apply to projections of less than 3,2 mm from the panel, provided that they are blunted and that the height of the projection is no more than half its width. ;The height of the projection is determined by the variation of the height of a 165 mm diameter sphere kept at the surface of the part and moved along it;Energy dissipation test 吸能试验;Impact direction : tangent to the trajectory of the spherical sphere used to determine the impact zone. Impact speed : 24,1 km/h This impact speed can be reduced to 19,3 km/h in case of an impact against parts that cover an undeployed airbag.;Test results : All the following criteria shall be fulfilled : Deceleration ? 80g continuously for more than 3 ms. No sharp edge during or after the test;Reference zone means the parts which can be impacted in the case of a frontal collision Reference zone may be determined, at the option of the car manufacturer, either statically or dynamically Dynami