钻井工程2答案（Drilling engineering 2 answers）.doc

钻井工程2答案（Drilling engineering 2 answers） I. judgment questions: 1., when locating a well, avoid mountain torrents, rainstorms, floods or landslides. () 2. high pressure test run as a bit water right, ensuring the highest pressure drilling in the highest discharge. () 3. inner flat joint is suitable for internal thickening and extra thick drill rod. () 4. the drill pipe joint is made of alloy steel whose material is higher than that of the drill pipe. () The square section of the 5. drill rod is square or six square for the purpose of transmitting the torque. () 6. roller bit teeth, milling teeth and carbide teeth two. () The 7. PDC bit is the abbreviation of a drill made of a composite block of natural diamond and tungsten carbide. () 8. drilling fluid can balance the rock side pressure of sidewall, form filter cake in the borehole wall, and seal and stabilize the borehole wall. () 9. drilling fluid can not effectively transmit hydraulic power. () 10. drilling fluid has high solid content and has no influence on drilling rate. () The wall thickness of the 11. square drill pipe is 2~3 times thicker than that of the drill pipe wall. () The generic dimension of a 12. square drill rod is the length of the square edge. () 13. the fittings of domestic drilling rod have three kinds: inner, through and normal. () 14. the performance specification of the sleeve mainly refers to the mechanical properties, size, thread type and strength of the casing steel. () 15.P-110 casing has higher hydrogen sulfide corrosion resistance. () The 16. class of drilling engineering report, well depth is equal to the length of drill and shift into the party and. () 17. the data units in the report of the drilling team shall be measured by the engineering units. () 18., soft shut in time is longer, in the process of shut in, formation fluid will continue to flow into the well, shut off casing pressure is relatively high. () 19. when the blowout preventer is closed, the ram BOP shall be switched o