喷涂、滚涂、弹涂（Spraying, roll coating, coating）.docVIP

喷涂、滚涂、弹涂（Spraying, roll coating, coating） Spraying, roll coating, coating The technical disclosure applies to general industrial and civil construction spraying, roll coating, coating and finishing. 1. material requirements (1) ordinary cement, No. 325 and above ordinary cement, slag cement, volcanic ash cement. The cement used in a project should be used in the same batch The products should be prepared in accordance with the design requirements. (2) fine aggregate: the use of a variety of small eight kg of waste, particle size of about 2mm of gypsum, rosin, stone, etc., can also be used in crude; Sand, but its mud content should be no more than 3%. (3) the pigment should choose light, good alkali resistance of the pigments, such as iron oxide red, iron oxide yellow, ultramarine blue, with a project should adopt the pigment With the same manufacturer, the same brand, the same batch of products, and should be prepared at once. (4) 107 glue containing solid content of 10% ~ 12%, pH value of 7~8, relative density of 1.05; silicone containing solid content of 30%, pH value of 13, relative density 1.23. (5) Huang Labu and black tape are determined according to need. 2. main machines and tools (1) general should be equipped with air compressor 1~2 (exhaust volume 0.6m3 / min, work pressure 0.6 ~ 0.8Mpa) pressure hose (3 / 8 oxygen can be used) Trachea and joint, nozzle, etc.. And use the pressure tank, 3mm shaker, hose, hose joint, spray gun. All kinds of rubber roller used for roll coating, loose scraper, elastic coating device used for elastic coating, window screening, material bucket, ash spoon, measuring balance, Wood trowel, iron trowel, line bag, cambric or black cloth, wooden ruler, square wooden ruler, etc.. (2) wooden rice strips, made in advance according to the design requirements. 3. operating conditions (1) the door and window must be installed in advance according to the design position and elevation, and check whether the installation is firm and the gap