伊莱克斯RM-275吸收式制冷机冰箱点火器和Spark更换电极-iFixit.PDF

Electrolux RM-275 Absorption Refrigerator Refrigerator Igniter and Spark Electrode Replacement Electrolux RM-275 Absorption Refrigerator Refrigerator Igniter and Spark Electrode Replacement This guide shows how to replace a faulty spark igniter module, spark electrode and igniter switch. Replacement parts were unavailable, but an igniter module from a more modern RM-64 1 fridge was used successfully. Written By : GrandadTom IN RODUC ION The Electrolux RM-275 Refrigerator works by a process called absorption, rather than the compression process that powers a standard household fridge. Instead of a compressor, it has a small heater, about 1 watts. The heating power source is user-selectable: mains, vehicle battery or gas bottle. The absorption process is less efficient than compression, but is popular for RVs, and camping trailers because of the power source flexibility , and for hotel minibars because it is quiet. This fridge is in a 2 -year-old RV. This type of fridge is now made by Dometic, who supply spares for some many old Electrolux-branded fridges - but unfortunately not for this one. The fridge worked fine on mains power or vehicle power, but it didnt work on gas. To set it to gas, switch on the spark igniter, which sparks about twice a second, with an audible tick and a flash of the switch lamp. Then turn the gas knob to full and press the knob to override the flame failure thermocouple. After a few seconds the gas will flow from the jet and the spark will ignite the flame. The igniter module senses the low resistance through the flame, and automatically stops the sparking and lamp flashing. After half a minute the flame failure thermocouple will be hot, and you can stop pressing the kn