集电环系统浅析（Collector ring system analysis）.docVIP

集电环系统浅析（Collector ring system analysis） Analysis of collector ring system In the rotary transmission and signal conduction rotation in the system requires a static conductor and a rotary dynamic conductor good contact, for the power transmission or signal transmission of the rotating rotating device called the collector ring (ring) system. In the collector ring system, the central ring is usually called the collector ring, and the conductor in contact with the collector ring is collectively called carbon brush. Brush made of precious metal, single brush or multi brush. Support and maintain the relative position of the brush brush device called the brush, and brush with the brush box name box, brush box installed on a device that can realize the brush pressure pressure refers to the pressure finger assembly and brush box are called brush assembly, also called brush. According to different requirements, the collector ring can be selected in the design and manufacture of different materials, the choice of materials, the first consideration of the current density is the transmission of the realization of environmental adaptation and mechanical performance protection. According to the configuration equipment use conditions, the purpose of revolution, equipment design life, product requirements, maintenance cycles and other factors considered. The collector rings include assembly type, mould type, bridge type, closed type, open type and so on. The material of the collector ring is based on the traditional experience of tin bronze, silicon brass, stainless steel, carbon steel and precious metal. In designing the collector ring system, the material of the collector ring is firstly considered according to the conditions of the use of the machine. After the material of the collector ring is determined, the current density and the linear speed are calculated according to the power, and then the material of the brush is selected. The correct selection of carbon brush material i