材料试卷2（Material examination paper 2）.docVIP

材料试卷2（Material examination paper 2） Highway engineering test engineer qualification examination questions (questions) (road construction materials subject - 30%) Note: the questions before with * the degree of difficulty for difficult, not as easy. A RadioButtonList (each of 1 points, a total of 6 points) *1. said 1 p assuming the true density of coarse aggregate, with p 2 said the apparent density, bulk density with P 3, P 4 with bulk density, while for the same kind of coarse material P 1, P 2, P 3, P 4 between the size relations (B). A. p 1 p 2 P 4 P 3; B. p 1 p 2 p 3 P 4; C. p 2 p 1 p 3 P 4; D. p 2 p 3 p 1 p 4; 2. 8% moisture content of fly ash 540g, the drying quality (C). A.496.8 g; B.504 g; C.500 g; D. can not determine 3. the most important evaluation indexes of lime quality is (A). The activity of A. and Magnesium Oxide B. calcium oxide content; fineness; C. D. carbon dioxide content; volume stability; The main mineral *4. cement clinker, the flexural strength of cement plays an important role in the (D). A. three B. two calcium silicate; calcium silicate; C. three D. calcium aluminate; ferritealuminate four calcium; Crush *5. test methods of aggregate for Highway Engineering in coarse aggregate value test method for rough set with cement concrete and asphalt concrete material, different load is applied in the test, the reason for (D). A. cement asphalt for inorganic materials organic materials; B. two concrete aggregates with different particle sizes; C. two concrete aggregates with different chemical properties; D. asphalt concrete through the roller in the construction process, high requirements on aggregate strength; 6. asphalt mixture usually void ratio of not less than 3%, the reason for (B). A. summer asphalt material expands; B. project will not void ratio is reduced to less than 3% C.; prevent water infiltration; rolling easy D. construction; Two, multiple-choice questions (each of 2 points, a total of 12 points) The basis for the evalu