监护仪使用操作流程（Monitor operation process）.docVIP

监护仪使用操作流程（Monitor operation process） Operation procedure of ECG monitoring Note: the key points for the quality. Alarm setting requirements: 1. ECG:HR - the basic 20-30%, set up according to the patients actual condition when necessary. Wave velocity 25mm/s. Open arrhythmia analysis and ST analysis (alarm limit is + 0.20mV). Open pacing analysis according to patient condition. 2. BP - the basic 20-30%, set up according to the patients actual condition when necessary. 3. SPO2 - 90-100%, when necessary, according to the patients actual situation. Wave velocity 25mm/s. 4. R - 10 ~ 30 / min, 6.25mm/s wave velocity. Grasp the main points: I. adjustment of amplitude and waveform sharpness. Answer: 1.FILTER (filter): reduce the false difference and interference due to other equipment. 2.DIAGNOSIS (diagnostic): a filtered ECG that shows the most realistic ECG wave. 3.MONITOR (guardianship): used in the normal monitoring state, can filter out false alarms that may cause false alarms. Two. Oxygen saturation can not be measured and the cause of measurement error. Answer: 1. nail bed condition is bad: such as gray nails, nail polish and so on. 2.. The decrease of intra arterial flow: shock, hypothermia, vasoactive drugs, anemia. 3. disturbed by blood or other substances in the skin. 4. the interference of a strong light in the surrounding environment (opaque material can be used to cover the sensor). Three. Causes of unreliable manometry or prolonged pressure measurement. Answer: 1., the patient moves, shakes or spasms; 2. arrhythmia, a very or very slow heart rate; 3. blood pressure changes rapidly; 4. severe shock or hypothermia; 5. obesity and edema patients. Four. Principle of monitor alarm setting. Answer: 1. patient safety. 2. minimize noise interference. 3. not allowed to turn off the alarm function, unless the rescue can be temporarily closed. 4., the alarm range is not set normal range, but should be safe range. Five. ECG characteristics of common arrhythmia. Answer: 1