cisco交换机原理与基本配置.pptVIP

Slide 1 of 1 Purpose: Emphasize: Note: The output shows that there are currently no ports assigned to VLAN 9. Slide 1 of 2 Purpose: Emphasize: By default, all ports are in VLAN 1. Slide 2 of 2 Purpose: Emphasize: Note: In the lab, we will only be configuring static VLAN membership. Slide 1 of 2 Purpose: Emphasize: Slide 2 of 2 Purpose: Emphasize: Port 1 = e0/1, ……. AUI = e0/25, A = fa 0/26, B = fa 0/27 Slide 1 of 1 Purpose: Emphasize: Notes: Refer to the lab setup guide for lab instructions. Slide 1 of 1 Purpose: Emphasize: 本章总结 通过本章的学习，您应该掌握以下内容: 配置VLAN 配置VTP 配置Trunk Slide 1 of 1 Purpose: Emphasize: Slide 1 of 1 Purpose: Emphasize: A VLAN is a broadcast domain. Note: In order to have inter-vlan communications, a router is required. Slide 1 of 1 Purpose: Emphasize: Note: Once a port has been assigned to a VLAN, it can not send or receive traffic from devices in another VLAN without the intervention of a layer 3 device like a router. The 1900 can’t be configure as the VMPS. A CiscoWorks 2000 or CWSI management station or a Cat 5000 switch can be configured as the VMPS. In the future, dynamic VLANs may also offer membership based on other criteria such as protocol or application. Dynamic VLANs are covered in the Managing Cisco Switched Internetworks class. Slide 1 of 3 Purpose: Emphasize: Each port on the switch can be assigned to a VLAN. By default, all ports are in VLAN 1, a factory default VLAN. Slide 2 of 3 Purpose: Emphasize: To allow VLANs to span across multiple switches, the connection between the switches must belong to mulitple VLANs. Slide 3 of 3 Purpose: Emphasize: A trunk is used to connect two switches together. A trunk carries traffic for multiple VLANs. Only the fastethernet ports on the 1900 can be configured as trunk port. Trunking is off by default on the 1900 fastethernet ports (fa 0/26 and fa 0/27). Note: The 1900 supports DISL. At the time of the beta, the core switch (2900xl) doesn’t suppor