jk,jlk（JK系列）.docVIP

jk,jlk（JK系列） The method of flat drawing is the abbreviation of flat whole representation, which is summarized as follows: 1. The production of flat method: the efficiency of traditional design method is low and the quality is difficult to control. Japans structural drawings without node construction details, node construction details by the construction company (construction unit) for the two design, design efficiency, quality assurance. The structural design of the United States only gives the reinforcement area, and the concrete reinforcement is done by the construction company. Accordingly, the traditional design methods of China must also be reformed. 2, the principle of flat method: design process: design structure system - structural analysis (mechanical analysis) - structural construction drawings design. The structure design is a kind of commodity, has the use value, is one kind of special commodity, divides into the creative work and the repetitive work (non - creative work). Now the structural engineer completes the creative design part (creative labor), the node structure and the outer node structure are not the work results of the structural engineer, and the copy standard. (Note: the node structure is out of the question. It was tested by researchers.) The traditional single component orthographic projection method mixes creative labor with non creative labor, and the design of joint structure and out of joint structure belongs to repetitive labor (non creative labor). Based on this, the idea of structural standardization and structural standardization is generated. The creative design is represented by the method of digital and symbolic representation, namely, the whole representation of plane. The plane whole design method, including the representation method and the standard drawing two parts. After the standardization of node structure, the construction company increased the amount of labor. 3, leveling application: in 1991 September, leveling began