井下工艺试题(初级)（The test process (primary)）.docVIP

井下工艺试题(初级)（The test process (primary)） Downhole process examination questions (primary) 180 questions 1, well control refers to the implementation of oil and gas wells (A) for short. A, pressure control B, oil and gas control C and formation control 2, well control in the three early content: early detection, (A), early processing. A, early shut in well B and early killing well C and early release spraying 3, when the bottom hole pressure (C) formation pressure, the wellhead back liquid is greater than the amount of pump liquid or after the pump, the automatic overflow of well fluid is called overflow. A greater than B equals C, less than 4, according to the blowout fluid blowout position is different, blowout can be divided into the ground blowout and (B) two. A, drilling, blowout B, underground blowout C, pipe blowout 5, (C) is a well control technique that uses hydrostatic pressure to balance formation pressure. A and three well control B and two well control C, level a well control 8, well control technology can be divided into (B) level well control according to control mode. A, two B, three C, four 9, overflow to prevent blowout, the only correct operation is (A). A shut the well in time according to shut in program. B make decisions based on construction conditions. C, cycle observation, shut the well according to the situation. 10, overflow flow (C), the more convenient for shut in control, the more secure. A, it doesnt matter B, the more C, less 11 and two level well control refers to the well control technology after the overflow or blowout occurs, through the timely shut in and pressure well reconstruction (B) balance. A and reservoir pressure B and borehole pressure C and formation pressure 13 、 shut in well is a well control technique that uses (A) and wellhead back pressure to balance formation pressure together. A and hydrostatic pressure B and bottom hole pressure C and riser pressure 14, the overflow is the root cause of the bottom hole pressure (B)