仪表考试题答案（The instrument exam questions.）.docVIP

仪表考试题答案（The instrument exam questions.） I. judgment questions: 1. The higher the measured pressure, the smaller the bellows structure of the pressure measuring instrument (*) 2, spring tube pressure gauge pointer shaft is mounted with spring, its purpose is to eliminate the gap between the transmission mechanism, reduce the instrument variation (V) In 3, Holzer transferred to the two meter pressure transmitter signal is a voltage signal (V) Right, laying 4 compensation wire, should from up to two times with the thermocouple instrument so far (V) 5. Pressure level can be used to measure the level of liquid in an open or airtight container 6, when the flow velocity is small, the inertial force of fluid plays a dominant role, and when the flow rate is higher, the viscous force plays a leading role. (x) 7, any two temperature of different metal objects contact, heat exchange phenomenon will occur. (V) 8 thermodynamic temperature and Celsius temperature are the same, but the starting point is different. (V) 9, integral adjustment has the disadvantage of hysteresis. (V) 10 standard throttling devices do not have to be equipped with isolators for measuring viscous and corrosive substances. (x) 11, the upstream and downstream of throttling device do not need enough length of straight pipe. (x) 12, electromagnetic flowmeter is not able to measure the flow of gas medium. (V) 13 、 the output current of electromagnetic flowmeter has linear relation with the flow of medium. (V) 14, the stroke of the valve stem and valve positioner input signal size is proportional to. (V) 15, proportional integral controller with large proportion, can improve the stability of the system. (x) 16 、 the signal line of the electromagnetic flowmeter is not allowed to be worn in a steel tube with the power cord. (V) 17. The role of the protective tube is to protect the thermocouple from chemical corrosion and mechanical damage. (V) 18 、 the installation of two directions of the standard orifice plate