弹塑性分析方法（Elastoplastic analysis method）.docVIP

弹塑性分析方法（Elastoplastic analysis method） Elastoplastic analysis method Analysis of name card encyclopedia pushover (PUSH-OVER ANALYSIS) for help editing method also known as Pushover Method, this method is based on the FEMA-273 seismic evaluation method and ATC-40 report, is a method between elastic analysis and elastoplastic dynamic analysis, which is the core theory of target displacement method and capacity spectrum method. Catalog Analysis 1. introduction 2.1 pushover 2.2 dynamic elastic-plastic time history analysis 3.1 the basic principle and method of 3 dynamic elastoplastic analysis 3.2 basic methods of elastoplastic dynamic analysis The 4 Engineering Application 5. Analyze 1. introduction 2.1 pushover 2.2 dynamic elastic-plastic time history analysis 3.1 the basic principle and method of 3 dynamic elastoplastic analysis 3.2 basic methods of elastoplastic dynamic analysis The 4 Engineering Application 5. Provisions of article 5.5.2, the editor of this paragraph 1. introduction code for seismic design of buildings, especially for the irregular structure, seismic plate column wall, bottom frame brick and the height is not greater than the reinforced concrete structure and steel structure of 150m steel structure, 7 degrees and 8 degrees three or four site B in the building should be playing plastic deformation. For more than 150m of the steel structure, a building structure should be elastic-plastic deformation checking. Regulations technology for concrete structures of tall building 5.1.13 is also provided for the high-rise building structure, B level height and complex high-rise building structure, such as conversion layer, strengthening layer and Cuoceng, conjoined, multi tower structure, adopt elastic-plastic static or dynamic analysis method to calculate the weak layer of elastoplastic deformation. The earthquakes in history has proved the necessity of elastoplastic analysis: Japan in 1968 ten Sheng Oki earthquake many seismic according to equivalent static