汽车驾驶实习指导书（Driving practice guide book）.docVIP

汽车驾驶实习指导书（Driving practice guide book） Two. Control the use of parts 1. Steering wheel It is used to keep and change the direction of the car moving parts. The force exerted by the driver on the steering wheel, the steering knuckle that passes to the front wheel via the steering wheel and the steering gear, turns the front wheel in the required direction, and when driving, the driver turns the steering wheel with both hands. You can only operate with one hand when you change gears, honk horns, or turn signals. If the steering wheel to the left in the clock case, then 9 words or 10 words, 4 words or 5 words in the right position is the most convenient. Dont hold tight the steering wheel, without the use of a large force, otherwise easily lead to fatigue, because good car front always try to keep itself commendatory terms linear motion position, this is because the tire is elastic, the front wheel front beam and angle, resulting in stable torque caused by the front wheel steering wheel and due to uneven road by accidental impact to the side, always strive to automatically return, but the uneven undulating large lots on the road, and in the sand, snow, muddy road, we must firmly hold the steering wheel, to avoid sudden severe turbulence in the grip the steering wheel. In line or on the road with little curvature, a hand, a hand should be supplemented, hands alternate operation sharp turn. 2. The gear lever is used to change the traction force of the drive wheel, to reverse the car and to make the engine idle. When operating, should press the clutch pedal, the right hand hold the gear lever, the upper end to the power of the palm to operate, when reversing, there are lifting button, you must lift the button, according to the stalls. It should be pointed out that the transmission lever should not be operated with great force and excessive motion. Otherwise, the gears and transmission devices may be damaged, and the gears and gears can be removed only when the clutch is s