复卷机岗（Rewinder post）.docVIP

复卷机岗（Rewinder post） There are many reasons for the uneven surface of the paper 1., rewinding speed is different, the cutting drum surface is different, such as surface evenness (acceleration is larger, the acceleration hours are sparse); 2. rewinding tension, paper tensile, resulting in tightness of a cylinder, easy deformation 3., the edge of the paper is different, resulting in edge cutting edge of the paper shaking violently, resulting in the disk is very uneven; 4., the width of the paper is different, easy to cause rewinding machine shock, and even undercut The rewinder paper loss pool concentration is too large, the degree of freedom of decline, leading to the edge of the paper suction slow over, serious side caused by knife edge in paper coaster, so in the end. The complex two, to damage the paper to a pool of water, the concentration of plasma in that pool under the action of stirrer in turbulence dynamic. edge guide By detecting the position of the paper, the paper can automatically shift the paper back frame and adjust the direction of the paper edge, so that the edge knife can evenly cut off the edges of the paper at both ends, and the single edge is not appeared Lift the press roll in two cases: 1. bottom roller, paper core has paper width When the door is closed, the press roll can be lifted and the press roll does not ring. The paper roll is opened (rewinding the last set) 2. bottom roller, paper core, no paper width Close the safety door, to see whether the web tension below 500KN/m, after opening the bottom roller vacuum after the web can suck lift (or paper pulled off the bottom roll paper or vacuum adsorption force is less than the web tension off); At the end of a knife (circular knife) knife edge front baffle blowing pinhole in the paper is running, the blowing tiny gap, plate and sheet edge separately, the frictional resistance between the two lowest, even zero; also play a supporting role to make the edge of the paper, by cutting out the edge o