球拍穿线（Racket threading）.docVIP

球拍穿线（Racket threading） The thread about badminton racket that knowledge had to say in 2011 01 months 08 days 17:11 Cleveland In the last issue of the magazine, we talked about the thread machine, the knowledge that we had to say, and introduced the knowledge of threading machine hardware. About threading knowledge and learning computer tutorials, like the first hardware chapter to introduce the basic configuration, and then to introduce the basic operation of the software. This issue focuses on the threading technology is that we will describe below software, simply as erengu forum thread version signature - horizontal line, vertical line, no. Ridicule can also see that many people do not actually wear the line as a matter. Nevertheless, after many years of in-depth induction and summary of the industry, coupled with the constant specialization, but also produced a lot of knowledge to share. At present, the industry has been recognized by the standard threading method: 1, four double threading method, namely YONEX instructions called standard racket threading, hereinafter referred to as the four; 2, two double threading method, namely GOSEN company threading and victory company promote the new threading method, hereinafter referred to as double two; At present, the industry is also tested by the threading method: the world around the wire, the MIZUNO TC series of rackets, such as special threading method. Has been considered not suitable for badminton racket wear line and was eliminated by threading method, two knot single pull through method (hereinafter referred to as two knot), false four knot single pull line method. The goal of standard threading is to maximize the original structure of the racket and maximize the flexibility of the ball line to maximize the resonance between the bat and the bat. Generally speaking, the first two points are what a standard thread maker should do, and the third point is what a mind maker should do. For the requirements of the f