硫酸配置与输送.docVIP

1.0 目标/Purpose 为电镀机台中和槽和集中溶液控制系统输送槽配备硫酸 To prepare Sulfuric acid solution for neutralization tank of Plating machine and dosing tank of CSCS 2.0 范围/Scope 提供配备硫酸(为中和槽和输送槽)的指南。 This instruction is a guideline to prepare neutralization tank of plating machine and dosing tank 3.0 职责/Responsibility 电镀、制程、实验室人员有责任遵守本程序。环保部门全体人员有责任执行本程序。 It is the responsibility for Plating, Process and Lab section to comply with this procedure. It is responsibility of Environmental section to maintain this procedure. C 4.0 定义/缩写/Definition /Abbreviation 4.1 H2SO4 硫酸 Sulfuric acid 4.2 DI 去离子水 De-ionized water 4.3 WWT 废水处理部门 Water Treatment section 4.4 Make Up 配制目标浓度的溶液 Chemical preparation to target concentration 5.0 参阅文件/Document reference 5.1 SLC集中溶液控制系统设计 Proposed Centralized Solution Control System For SL 6.0 化学药品/设备/Chemical /Equipment 硫酸配制 H2SO4 make up 6.2 硫酸输送槽 H2SO4 dosing tank 6.3 配制 Make up 6.4 硫酸浓度 60% Sulfuric acid conc. 60% 6.5 去离子水 DI water 6.6 人身防护装备 Personal Protective Environment (PPE) 7.0 流程与操作程序 Flow and Operation procedure 7.1从配制槽传送硫酸到电镀机中和槽 H2SO4 transfers from Make Up tank to neutralization tank in plating machine 序号 流程 process 图片或示意图 Photo or sketch 描述 Description 安全指导 Safety guidelines 7.1.1 设定配制体积 Determine tank volume for Make Up 设定配制体积后，用小车 将药品转移至CSCS Transport the chemical from A/A store to CSCS 佩戴全面罩，橡胶手套，橡胶袖套，穿围裙 Wearing the full face piece mask, the rubber glove the rubber over sleeve and the apron 7.1.2 往配置槽内加入DI水 Add DI water into the make up tank 加入设定体积一半的DI水到硫酸配制槽中 Fill up H2SO4 Make Up tank with 50% of DI water 佩戴全面罩，橡胶手套，橡胶袖套，穿围裙 Wearing the full face piece mask, the rubber glove the rubber over sleeve and the apron 7.1.3 往配置槽内加入硫酸 Add sulfuric acid into the make up tank 慢慢加入硫酸 Add Sulfuric Acid slowly 佩戴全面罩，橡胶手套，橡胶袖套，穿围裙 Wearing the full face piece mask, the rubber glove the rubber over sleeve and the apron 7.1.4 往配置槽内加入DI水 Add the DI water i