pads2007精点用法--深圳新研创科技（Pads2007 precise point usage -- Shenzhen new research and development science and technology）.doc

pads2007精点用法--深圳新研创科技（Pads2007 precise point usage -- Shenzhen new research and development science and technology） PCB drawing technology, 2009-10-12 11:10 reading, 242 reviews, 0, size: big, medium and small 1:PADS novice point of experience and skills, even PADS novice, the original has been using protel. It took four days to draw a large board with PADS2005 for the first time, and there were a lot of uncomfortable and unfamiliar places at first. Now its an introduction. It also summarizes some experiences and techniques. I hope PADS novice can help. 1. layout of the fly line (mouse line, connection) processing. The default setting for Layout is not to minimize the fly line. At the beginning of the cloth component, the flying line is really dense like cobweb, confused and disoriented. Tools\length minimization (CRTL + M) is no use, and the device layout is completed by default in default settings. Want to faint. Later found that it was not set up. The correct or convenient setting should be to make the line shorter and always shortest in movement. Setup\design, rules\default, rules\routing\, topology, type\minimize In this way, by pressing CTRL + M, a lot of flying lines disappear, and thats the shortest Setup\preference\length minimize\during moving In this way, the moving element is always the shortest flying line. In addition, a lot of flying wires are actually ground wires. The fly line of the ground wire can be hide first. And set the ground net to a more special color. This will make the layout much easier. View\nets\ to the left, net list, GND net, and to the right view list. On the right, select GND, the following view unroute details, select none, and choose a color in the left color. Thus, the line of the earths line rises hide and is of the same color. Of course, be careful here. Signal and power should be separated first. Such settings are much easier to layout. I knew it, ft. 2. change font properties of all components. Like Protel, this can be chang