动手装电脑（DIY computer）.doc

动手装电脑（DIY computer） 1 install power Install the power that comes with the chassis and, in general, has a direction. Most ATX power supplies now have a switch to control the machine. 2 gongs should be made in inch (rough, left). Under normal circumstances, the power, hard disk, chassis to use coarse thread screw fixed, CD-ROM drive, floppy drive with West grain screw fixed, and the motherboard, the tailgate varies with the chassis Three Install the motherboard Sets the operating frequency of the CPU Before installing the main board, refer to the manual to set the working frequency of the CPU, including two aspects: a.CPU external (bus) frequency setting B.CPU internal clock frequency setting. That is, CPU is the working frequency of the two. Some motherboards use switch settings, the same as jumper. The bus frequency of the ASUS P2B motherboard can be set to 66,75,83,92100102113133MHz CPU internal clock frequency doubler can be set to 2.0-8.0, interval of 0.5. The CPU we use is 350MHz, set to 100X3.5=350 4 install CPU and CPU fans: Lets take SLOT1 CPU as an example: A. install the CPU bracket B. install CPU, The concave part of the gold finger of the CPU is convex to the CPU slot, and the CPU is vertically inserted into the bracket of the CPU, and the CPU is installed when the is issued. The CPU fans power cord is plugged into the fan power interface on the motherboard, CPU:Intel PII 350 5 install the memory bar Now use more than 168 lines of DIMM memory, the motherboard is only DIMM slot. The golden finger of the memory is divided into two parts. It is not equal. When it is inserted, it will not reverse the direction. Memory: 64M PC100 (HY 57V658020A) 6 fix the main board on the chassis bottom board Screw in the stem and plastic studs attached to the chassis and the chassis. Metal pins must be used at both ends of the keyboard on the motherboard. Put the motherboard flat in the case and screw the main board. Note that the peripheral interface of the ATX board shou