单片机lcd1602显示（Singlechip LCD1602 display）.docVIP

单片机lcd1602显示（Singlechip LCD1602 display） 1, the microcontroller out of the PNP pipe, and then pick up a NPN pipe just fine 2, power Now, in fact, the MCU and the relay are using the same 5V power supply Both NPN and PNP drive problems exist. Now all I can think of is..: The MCU and the relay are separately powered, and the relay uses LM317 as a slow on circuit, enabling the relay to power over the MCU, and it is estimated that it can solve the problem. I wonder if there are any other better solutions? 3, the power supply process light, SCM is not good Even if sometimes correct, dare not say re