中财讯212年2月份课题.doc

2012“税感时代”减轻“税负痛苦指数”实操系列培训 2012年纳税风险识别和评估方法——纳税零风险管理模式 2012年进一步做好税收征管工作的通知深化纳税评估，强化税源管理加强税务稽查，规范税收秩序税务稽查的方法及税务稽查1100 1068 9000 5250 1709 会务费三日之内汇入上述账号，汇款凭证传真至会务组。 参会单位领导批示： 盖 章 2012年 月 日 1、联 系 人： 赵航 2、咨询电话： 024 3、传 真： 024 瑞昌财学院 中国财税咨询网 北京中财讯财税筹划技术研究院 2012-02-01 中央财经大学财经研究院、中财讯瑞昌财学院联合推出 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you