机械类资料（Mechanical data）.docVIP

机械类资料（Mechanical data） Do mechanical design of this line entry and indispensable 1. parts This kind of parts usually have a shaft, bushing and other parts, in view of expression, just draw a basic view plus appropriate sections and dimensions, you can put its main shape characteristics and local structure express. In order to facilitate the processing of pictures, according to the horizontal projection axis, the best choice for the position of the vertical axis side. In the labeling of parts size, often with its axis as the radial dimension benchmark. The system shown in Figure 14, with the diameter of 11 (see section A-A). This put the process based on design requirements and processing (the shaft machining in lathe, both ends with thimble to resist center hole axis) unified. The length of the benchmark used important end face, the contact surface (shoulder) or surface processing etc.. As shown in the figure of the surface roughness is Ra6.3 of the right shoulder, the main dimension benchmark was chosen as the direction of the length of the 13, 28, 1.5 and outjection 26.5 dimensions; then based on the auxiliary shaft end for the right length, which marked the axis length of 96. 2. plate-like parts The basic shape of this kind of parts is disc flat, generally end cover, valve cover, gear and other parts of the main structure, they generally have a revolving body, the local structure often with various shapes, uniform hole and flange rib etc.. In view of the selection, the general selection section view of symmetry or the axis of rotation as the main view, also need to add other appropriate views (such as the left view and right view or view) the shape of the parts and uniform expression structure. As shown in figure adds a left view, in order to express the square flange with rounded corners and four evenly distributed through holes. In the annotation of plate-like parts size, usually choose axis of the shaft hole as the radial dimension benchmark, main dimensions o