天津中德业技术学院党政领导班子暨个人.docVIP

天津中德职业技术学院党政领导班子暨个人 2009年度述职报告 天津中德职业技术学院党委书记 陈金琦 2009年是学院实现科学快速发展最为关键的一年、也是应对挑战攻坚克难最为严峻的一年。一年来，学院高标准高质量加强了国家示范性高职院校建设，高起点高水平规划设计并开工建设了海河教育园中德新校区，按照高度统一、高度融合的要求准备和实施了原两个中心组建新中德的整合工作。学院党政领导班子不断加强自身建设，带领全体教职工坚持以邓小平理论和“三个代表”重要思想为指导，深入贯彻落实科学发展观，全面贯彻党的十七大、十七届三中、四中全会精神，认真落实市九次党代会和九届历次全会部署，紧紧围绕“抓统一、促融合、增内涵、上水平”，以“抢抓机遇，干事创业，传承创新，追求卓越”为目标，以加强内涵建设、提高教育教学质量、拓展培训咨询领域改革课程内容、教学方法、教学手段和评价方式，建一批优质核心课程和特色教材勤 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the