NSNWCDMA切换参数数据框架分析.pptVIP

100 sets for intra-freq, 100 sets for inter-freq and 100 sets for inter-system Benefit of Parameter Sets: Modification of Set is simple, one change implements changes to all cells on RNC HOPS parameters Cell Re-selection HCS Priority Cell Re-selection HCS Threshold Cell Re-selection Minimum Quality Cell Re-selection Minimum RX Level Cell Re-selection Penalty Time Cell Re-selection Quality Offset 1 Cell Re-selection Quality Offset 2 Cell Re-selection Temporary Offset 1 Cell Re-selection Temporary Offset 2 CPICH Ec/No Averaging Window Enable Inter-RNC Soft Handover Enable RRC Connection Release HHO Margin for Average Ec/No HHO Margin for Peak Ec/No Release Margin for Average Ec/No Release Margin for Peak Ec/No It is always important to be connected to the best server (best Ec/Io). Since there is no periodic reporting -HO the evaluation is done by UE. To inform RNC about these case, 3 events are defined. System Info: how should UE measure Measurement control: threshold for when to report The AS should always contain the X cells with the strongest CPICH – if the CPICH is within a certain range of the strongest CPICH. Three events can occur: enter, leave, replace. In this case the AS is NOT full event 1A – otherwise it would be event 1C! Determine reference level (either strongest CPICH or mixture of AS CPICH) Threshold when to add new CPICH How long the new CPICH has to be above threshold before is reported as 1A If not added to AS when to notify network again Is Time to trigger: AdditionTime / 0 = 0 ms a sensible value?? There is no replacement for P CPICH 3 – otherwise it would be 1C replace Default parameters to be used for Window_add/Window_dropNRT/ Like T31 and T32 in GSM Individual Ncell Offset time P CPICH 1 P CPICH 2 P CPICH 3 Reporting Range Reporting Event 1B Reporting Event 1A AdjsEcNoOffset Enlarging Cell 3 by x dB Ec/Io Branch addition RRC: Measurement Report (e1a) RRC: Active Set Update RRC: Active Set Update Complete RRC: Measurement Report (