塑料模具业术语.doc

塑料成型模具（简称塑料模具）mould for plastics 按塑料件材料分 热塑性塑料模具 mould for thermoplastics 热固性塑料模具 mould for thermosets 按成型工艺分 压缩模compression mould 压注模 传递模transfer mould 注射模injection mould 热塑性塑料注射模 injection mould for thermoplastics 热固性塑料注射模 injection mould for thermosets 按溢料分 溢式压缩模flash mould 半溢式压缩模semi-positive mould 不溢式压缩模 positive mould 按机外、机内装卸方式分 移动式压缩模 portable compression mould 移动式压注模 portable transfer mould 固定式压缩模 fixed compression mould 固定式压注模 fixed transfer mould 按浇注系统分 无流道模具 runnerless mould 热流道模具 hot runner mould 绝热流道模 insulated runner mould 温流道模 warm runner mould 浇注、排溢和分型 浇注系统 feed system 主流道 sprue 分流道runner 浇口gate 直接浇口direct gate; sprue gate 环形浇口ring gate 盘形浇口disk gate diaphragm gate 轮辐浇口spoke gate; spider gate 点浇口pin-point gate 侧浇口edge gate 潜伏浇口submarine gate runnel gate 护耳浇口tube gate 扇形浇口fan gate 冷料穴cold-slug well 浇口套sprue bush sprue busing 浇口镶块gating insert 分流锥spreader 流道板runner plate 热流道板（柱）manifold block hot-runner manifold 温流道板warm runner plate 二级喷嘴secondary nozzle 鱼雷形组合体torpedo torpedo body assembly 管式加热器cartridge heater 热管heat pipe 阀式浇口valve gate 加料腔loading chamber(in a compression mould) transfer pot(in a transfer mould) 柱塞force plunger,pot plunger 排溢溢料槽flash groove spew groove 排气槽（孔）vent(of a mould) 分型分型面 parting line 水平分型面（线） horizontal parting line 垂直分型面（线） vertical parting line 模具零件 成型零件 定模stationary mould fixed mould 动模movable mould moving mould 上模upper mould upper half 下模lower mould lower half 型腔cavity(of a mould) 凹模impression cavity block cavity plate 镶件mould insert 活动镶件movable insert loose detail 拼块splits(of a mould) 凹模拼块 cavity splits 型芯拼块core splits 型芯 core 侧型芯side core slide core 螺纹型芯thread plug threaded core 螺纹型环 thread ring threaded cavity 凸模 punch ; force 嵌件 insert(for mould) 支承与固定零件 定模座板 fixed clamp plate top clamping plate top plate 动模座板 moving clamp plate bottom clamp plate bottom plate 上模座板 upper clamping plate 下模座板 lower clamping plate