2010国家基金申请书撰写注意事项.doc

2010年国家基金申请书撰写注意事项 ** 请于2010年1月1日以后在国家基金网站（）下载最新版的申请书。 ** 请一定确保申请书的所有内容真实、准确和合法，申请书中字体加大加粗，行距加大，方便专家网上评审。 ** 研究起始年限一律填写2011年1月1日。 ** 所有签字日期请打印上去，统一写2010年3月12日。 形式审查 年龄限制：青年基金申请人应是1975年1月1日（含）以后出生的；杰出青年基金申请人应是1965年1月1日（含）以后出生的；海外及港澳学者合作研究基金申请人应是1960年1月1日（含）以后出生的。 超项审查： 具体项目类别的限项申请规定见一览表。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface and internal cylinder surface height difference, compared with the