Weblgic 10 数据源配置操作手册.doc

Weblogic 10 数据源配置操作手册 第一步：登录Weblogic Service 控制登录台 打开浏览器访问Weblogic Service 控制台 第二步：以weblogic用户登录 第三步：配置数据源 点击“锁定并编辑”（如下图所示） 出现下图 点击“服务”-“数据源”，出现下图 创建数据源 点击“新建”（如下图所示） 选择一般数据源，出现下图。 填写名称（公司默认以ds_开头），JNDI名称，选择数据库类型，此处以ds_rsmis为例（如下图所示）。 点击“下一步”，出现下图，可选择数据库驱动程序 点击“下一步”，出现下图 点击“下一步”，出现下图 填写数据库名称，主机名，端口，数据库用户名，口令，确认口令。（如下图所示） 点击“下一步”，出现下图 查看无误后，点击“测试配置”，出现下图 点击“完成”，出现下图 完成数据源创建 修改数据源 双击数据源名称（如下图所示 ） 进入下图界面，可进行数据源多项的修改（如下图所示） 修改后,单击“保存”，即可完成修改。 删除数据源 选择数据源名称（如下图所示） 点击“删除”，出现下图 点击“是”，出现下图 完成数据源的删除。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks o