网络游戏览会招展策划书.doc

招展策划书 策划人：辛薛亮 策划时间：2010.02.15 目录 展区与展位规划图…………………………………………（01） 目标参展商确定……………………………………………（02） 招展人员分工………………………………………………（03） 招展价格……………………………………………………（03） 招展函………………………………………………………（04） 招展手段……………………………………………………（05） 招展预算……………………………………………………（05） 招展进度表…………………………………………………（05） 展区与展位规划图 目标参展商确定 全国: 山东盛大科技股份有限公司广州网易计算机系统有限公司北京完美时空网络公司广州金山多益网络公司腾讯科技（深圳）有限公司 厦门华商盛世网络有限公司重庆智佳信息科技有限公司北京中企网动力数码科技有限公司创联万网国际信息技术(北京)有限公司(中国万网)厦门中资源网络服务有限公司 陕西亚信科技有限公司 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support