使用linux heartbeat (心跳)的一些经验.docxVIP

使用linux heartbeat 的一些经验字体大小：大 - 中 - 小skyxia ? 发表于 09-03-15 19:51 ? ? 阅读(1056) ? 评论(0)硬件：2台hpe800,一条心跳线用于串口信息的检测，一条交叉线用于UDP协议的通讯。双网卡，一块用于连接交叉线，一块用于连接交换机。软件：REDHAT 7.3(MANDRAKE 8.2测试也通过)，heartbeat--1.i386.rpm其它准备：HPE800（1），主机名：CLUSTER-101-SERVER ，IP地址：01HPE800（2），主机名：CLUSTER-101-SERVER ，IP地址：01虚拟主机名：CLUSTER-SERVER ，IP地址：00从 网站下载最新的Heartbeat 软件包，目前的版本为heartbeat-，分别解压：rpm –ivh heartbeat--1.i386.rpm。首先配置第一台hpe800 ，解压后得到目录/etc/ha.d， 主要配置三个文件/etc/ha.d/ha.cf、/etc/ha.d/haresources、/etc/ha.d/authkeys我主要配置的http 与 smb的HA集群，三个文件的主要配置如下：/etc/ha.d/ha.cf# If any of debugfile, logfile and logfacility are defined then they# will be used. If debugfile and/or logfile are not defined and# logfacility is defined then the respective logging and debug# messages will be loged to syslog. If logfacility is not defined# then debugfile and logfile will be used to log messges. If# logfacility is not defined and debugfile and/or logfile are not# defined then defaults will be used for debugfile and logfile as# required and messages will be sent there.## File to wirte debug messages todebugfile /var/log/ha-debug### File to write other messages to#logfile /var/log/ha-log### Facility to use for syslog()/logger#logfacility local0### keepalive: how many seconds between heartbeats#keepalive 2## deadtime: seconds-to-declare-host-dead#deadtime 10### Very first dead time (initdead)## On some machines/OSes, etc. the network takes a while to come up# and start working right after youve been rebooted. As a result# we have a separate dead time for when things first come up.# It should be at least twice the normal dead time.#initdead 120## hopfudge maximum hop count minus number of nodes in config#hopfudge 1## serial serialportname ...serial /dev/ttyS0### Baud rate for serial ports...#baud 19200## What UDP port to use for communication?#udpport 694## What interfaces to heartbeat over?#udp eth1## Set up a multicast heartbeat medium# mcast [dev] [mcast group] [port] [ttl] [loop]## [dev] device to send/rcv heartbe