解决局域网网速慢（LAN slow）.docVIP

解决局域网网速慢（LAN slow） The enterprise network fault down the speed to solve the network maintenance personnel should have the corresponding knowledge, so as to timely and effectively find and solve problems. Hardware failure caused by LAN speed slow Cable status, cable joint, hub, card, driver and hardware equipment and so on are likely to cause the enterprise LAN speed slow. In most cases the speed suddenly slow down is due to hardware failure caused by network. When we first need to check whether there is no cable loss, damage fracture; cable joint is loose, bad contact; the hub is loose or interface is covered with dust or debris, causing blockage; and the card is working properly, the IP address is not set and other computer settings have conflicts. DNS fault let LAN speed Win2000 LAN after running for a period of time based on that whole network speed suddenly slow: running the company information system software and access to the corporate LAN homepage was decreased as well as the access to the network speed. In determining the transmission and no hardware problems, use the Ping command to test, not only to the internal Ping Ping router homepage on the LAN port is intermittent. In order to find the cause of the fault, that comes with the Win2000 network monitor, monitor the use of network bandwidth, the peak frequency of use and is transmitting data frames by monitoring data to analyze whether caused by network congestion. Run the network monitor, through the statistical data capture window, found the average network utilization rate above 50%, and most points to the router. Stop capture, press the F12 button to display the captured data, we can see that more than 70% of the data frames are sent by the DNS service. The DNS data frame so much a network is very unusual, can basically determine the fault is due to DNS. Carefully check the configuration of DNS, found that the server is selected using the attribute list entry transponder, another host (Server2), when t