3. Final thesis INFLIBNET（3所示。）.pdfVIP

BIBLIOGRAPHY [1] Tolga Bozdana, “On the mechanical surface enhancement techniques in aerospace industry – a review of technology”, Aircraft Engineering and Aerospace Technology: An International Journal 77/4, 2005, pp. 279-292. [2] E. G. Herbert, “The work hardening of steel by abrasion, with an appendix on the “cloudburst” test and super hardening”, Journal of Iron and Steel 11, 1927, pp. 265-282. [3] Flake C. Campbell, “Elements of Metallurgy and Engineering Alloys”, “Fatigue”, Chapter 14, ASM International, 2008. [4] I. Altenberger, B. Scholtes, U. Martin and H. Oettel, “Cyclic deformation and near surface microstructures of shot peened or deep rolled austenitic stainless steel AISI 304”, Materials Science and Engineering A264, 1999, pp. 1-16. [5] PROTO Manufacturing: Automated XRD systems service, “X-ray Diffraction Residual Stress Measurement – An Introduction”, 2011. [6] E. Brinksmeier, Hannover and J. T. Cammett, “Residual Stresses - Measurement and Causes in Machining Processes”, Annals of the CIRP Vol. 31, 1982, pp. 491-510. [7] P. Prevey, D. Hornbach and P. Mason, “Thermal residual stress relaxation and distortion in surface enhanced gas turbine engine components”, Proceedings of the th st 17 Heat Treating Society Conference and Exposition and the 1 International Induction Heat Treating Symposium , Eds. D.L. Milam et.al., ASM, Materials Park, OH, 1998, pp. 3-12. Page 133 [8] Thoma