CYCLOPS OSD USER MANUAL V4.0 HiModel（独眼巨人V4.0 HiModel OSD的用户手册）.pdf

CYCLOPS OSD USER MANUAL 5.0 Thank you for choosing CYCLOPS OSD V5.0 New features: CYCLOPS OSD V5.0 is incorporated with Autopilot function and infrared attitude sensor capable of controlling aircrafts attitude, and is able to control the aircraft with aileron and elevator based on preset controlling parameters. This OSD has 8 autopilot waypoints available apart from the launching point and is able to fully control the aircraft during waypoint autopilot and home-returning. In addition, the user can set the center , radius, and the direction of circling to enable the aircraft to fly in circle at certain point. The OSD also features 10HZ GPS module, compass indicator, modified autopilot program, reduced size and lighter weight. The OSD consists of several components including: OSD Main board 18g） Voltage and current sensor 50V、100A）11g） 10HZ GPS Module(9.5g) Setting board(5g Infrared attitude sensor(8g) Connection diagram Current sensor connection diagram Power supply jumper: Connect pin 1 and pin2 to use power battery as the power supply(the power battery must be 12V or 3S Lipo); connect pin 2 and pin 3 to feed OSD, camera and video TX with addit ional 12V power supply. Current sensor connection diagram How to use Cyclops OSD Connect the component according to the above, power it on, and the OSD gives such texts on the screen. The GPS starts to search for satellites; the signal strength icon at the right top indicates the found satellite number. Flashing icon indicates that no satellite is found or the GPS signal is too weak to be used for positioning (positioning progress will take 1-5 minutes when the GPS signal is favorable depending on environment.) Go up a