Technical drawing specifications（技术制图规范）.pdf

Technical Drawing Specifications Resource A guide to support VCE Visual Communication Design study design 2013-17 1 Contents INTRODUCTION The Australian Standards (AS) Key knowledge and skills THREE-DIMENSIONAL DRAWING PARALINE DRAWING  Isometric Drawing  Planometric Drawing PERSPECTIVE DRAWING  One-point perspective  Two-point perspective ELLIPSES TWO-DIMENSIONAL DRAWING PACKAGING NET FLOOR PLANS AND ELEVATIONS THIRD-ANGLE ORTHOGONAL DRAWINGS  The views  Plan your layout  Placement of views  Labeling orthogonal drawings LINE STYLES AND CONVENTIONS  Using these lines  Lines that coincide  Third – angle orthogonal Projection Symbol DIMENSIONING AN OTHOGONAL DRAWING  Dimension placement  Dimensioning circles ARCHITECTURAL CONVENTIONS  Architectural drawing  Dimensioning and symbols for architectural drawing 2 VCE Visual Communication Design 2013–2017 Technical Drawing Specifications Resource INTRODUCTION This resource material is intended to provide advice and support on technical drawing specifications relating to key knowledge and skills in VCE Visual Communication Design study 2013-17. The content of this resource document offers guidance for technical drawing conventions relevant to the fields of practice that Visual Communication Design students explore. This includes communication, industrial and environmental design. This resource document draws upon conventions from the Australian Standards (AS). Specified labeling has been included in this resource for teaching and learning purposes. Students undertaking Units 1 – 4 of this study are not expected to k