碳纤维布加固（CFRP reinforcement）.doc

碳纤维布加固（CFRP reinforcement） Three, bridge carbon fiber reinforcement construction technology 1, carbon fiber reinforcement construction steps Surface treatment of concrete components - brushing the bottom adhesive - sticking carbon fiber cloth - brushing protective adhesive - curing - coating other parts of the beam - quality inspection 2, carbon fiber reinforcement construction technology 1) surface treatment of concrete members First, the concrete parts of the damaged surface, damaged part of the chisel, clean, and to achieve structural dense parts. Check whether exposed steel bars are rusted, and if necessary, rust removal shall be carried out. After the parts of the structural parts which are cut, cleaned and exposed, the epoxy mortar, which is higher than the strength of the original component concrete, is repaired and restored to the surface. Crack repair: Cracks of width less than 0.2mm, with epoxy resin daub surface sealing; more than or equal to 0.2mm cracks, epoxy resin seam. (concrete construction, crack closure, construction technology) The surface of the component protruding parts (concrete components, parts of the handover, the section of the template, such as poor) polished, smooth, the difference between the trim to smooth. The angular position, with grinder rounding, minimum radius of not less than 20mm. Clean the surface of the polished element and make it sufficiently dry. Before construction, according to the design drawings, the reinforcement parts should be laid and positioned. 2) brushing the base adhesive According to the required proportion of glue, take ZHG-3 (dipping glue) A material and B material, weight ratio 3:1, pour into clean container, mixing with mixer evenly. Once the amount of adjustment should be used within the available time as the standard, more than the use of time can not be used again. Brush with a roller brush evenly dipping glue, brushing on the pasted parts, in the lap, corner parts, more appropriate brushing. When the