linux多点触控协议（Linux multi touch protocol）.docVIP

linux多点触控协议（Linux multi touch protocol） brief introduction In order to use a powerful multi touch device, one solution is to report detailed finger touch data to the user layer. The multi touch protocol described in this document allows the kernel driver to report any multi finger data to the user layer. Instructions Any one finger touch data is packaged into a ABS event package in order to send only ABS_MT event packets can be identified as the multi touch data, call input_mt_sync () function can generate a SYN_MT_REPORT event, the function of receiving and processing the information and finger touch information ready to receive the other fingers. Finally, call the input_sync () function to report to EV_SYN/SYN_REPORT Event completes the start of a package and prepares to process the next package. The ABS_MT protocol defines the attributes of events, these events are divided into several categories, allowing only a part of the application, multi touch events should be minimum including ABS_MT_POSITION_X and ABS_MT_POSITION_X, these two events are used to describe the multi touch finger touch trajectory. If the device supports the two events, then ABS_MT_TOUCH_MAJOR and ABS_MT_WIDTH_MAJOR are used to provide finger size and touch area size, respectively. The TOUCH and WIDTH parameters are given, if one finger on the glass through the glass, you will see two regions, one is the contact finger and the glass area, described by ABS_MT_TOUCH_MAJOR, is an area the size of the finger itself, ABS_MT_WIDTH_MAJOR description, contact fingers and the glass area is smaller than the finger itself the size, through these two parameters, can be converted to pressure shot. The finger pressure can also be supplied directly through the ABS_MT_PRESSURE parameter. In addition to the MAJOR parameters, can also provide a MINOR parameter, the finger can be thought of as an ellipse, MAJOR and MINOR can be considered and the short axis of the long axis of the ellipse, the ellipse center can