b6ac中文（B6ac Chinese）.doc

b6ac中文（B6ac Chinese） BC6 and Chinese instructions set A charger parameters: Voltage value: DC11.0-18.0V -50/60HZ 12V DC 5A optional AC100-240 adapter The maximum charging power: 50W The maximum discharge power: 5W - charging current value: 0.1-5.0A Discharge current value: 0.1-1.0A Current single battery: 300mah/cell - Ni MH / Ni Cd battery number: 1-15cell Lithium ion / polymer series: 1-6 (Note: support Li-Fe battery, A123) PB battery voltage: 2-20V The two key functions. Batt. Type / Stop button: battery type and stop button, you can use the electric switch button in the main menu, press this button can stop charging; Dec. / Inc. Status button: reduce and increase button, set a variety of numerical Dec. is reduced, Inc. is increased, when charging according to the two button to browse different battery information; Start / Enter: Start button and select button. Three instructions. The power supply is switched on, which display the main menu At this point you can press Batt. Type / Stop button, switch on several main menu, they are: 1) Program Select LiPo BATT The main menu to charge and discharge the battery series 2) Program Select MiMH BATT The main menu to charge and discharge the battery 3) Program Select NiCd BATT The main menu to charge and discharge the nickel cadmium battery 4) Program Select Pb BATT The main menu of the battery charge and discharge 5) Program Select Save Data Save the data set menu 6) Program Select Load Data Loading the data menu 7) User Set Program- User settings menu The lithium battery charge and discharge 1.) charging After boot display the main menu: Program Select LiPo BATT Determined by Start / Enter button Screen display LiPo CHARGE *.*A *.*V (*S) This is a lithium battery charging, non balanced charge, so is not recommended to continue. (suitable for lithium battery without balance terminals) According to Inc. , screen display: LiPo BALANCE *.*A *.*V (*S) This is the balance of lithium charging function, is the charge balance