hp绘图仪（HP plotter）.docVIP

hp绘图仪（HP plotter） Maintenance method using HP plotter 2009-06-01 file source: (reading) times (252) Maintenance method using HP plotter 1. connected with computer: The new plotter after purchase, does not provide the interface cable connected with the computer, the user can create a standard interface, it has two kinds of serial and parallel interface standard, as follows: Serial interface, parallel interface, plotter (25 pin), a computer (9 holes), the plotter (36 pin), a computer (25 pin) 41 11 22 22 33 54 75 87 1414 3018 (Note: 1-14 foot is connected with) Due to the speed, recommend the use of the parallel port as interface standard. Connect the 2. test with the computer: The first and the plotter connected, the DOS under test computer and plotter is normal, the test can be used as follows: (1) the use of serial communication, the first set 9600 baud rate setting in the plotter page, no parity (no payity), if you do not do any settings using the parallel port; (2) at the DOS prompt type mode coml:9600, N, 8,1, P or mode lptl: p; (3) type echo in; SPL; PA0, O; P SP0; PG; coml; (4): echo in; SPL in parallel; PA01 0; PD1000, 1000, spo; PG lptl; If a 25MM plotter can draw the diagonal, that connected with computer by plotter. 3.I /O hot swap function: I/O hot swap is a kind of equipment can not receive data from a plurality of the same port automatic switching ability of the HP 650CA / B 750C plotter, /755CM, 330350C, 700750C PLM has a I /O hot swap function. For example: first through the parallel port to send a print job, and then through the serial port to send another print job, if the device does not have I /O hot swap capability, you must be off to send another job from port. 4. drawing set: The new machine can be tested after the repurchase, the setup sheet (page set), the setup sheet and some characteristics of the plotter plotter and its settings. The test method is that post, to be ready light, put the size of A4 copy paper press set button to pr