u盘修理办法（U disk repair method）.docVIP

u盘修理办法（U disk repair method） U disk fault solution The following faults in maintenance, we should exclude USB interface damage and PCB plate weld, and USB extension line under normal conditions, and then determine the maintenance. 1. U disk is inserted into the machine without any reaction Maintenance ideas: judgment according to the fault phenomena, U disk machine did not work, and have U disk tool condition is the focus of our maintenance. No matter any solution to the U disk work must have the following conditions: (1) power supply, power supply of main control required for power supply and FLASH required, the two is the key, and the U disk circuit is very simple, such as no power supply is generally damaged or 3 Insurance inductance. 3V regulator block damage, said the regulator block here also said that the three pins are respectively the power input (5V), and the output of the power supply (3.3), the working principle is that when the input pin of a 5V input voltage, output pin will output a stable 3.3V. Just check where is the root of no power supply, it will be well resolved. (2) the master clock, due to the frequency of work, communication with the FLASH to * clock signal to be transmitted, so if the clock signal is not the main control will not work. When this check circuit, clock generating circuit is very simple, only need to check the crystal and its peripheral circuit can, for fear of brush and U crystal compact disk is easy to fall caused by crystal damage on the ground, as long as the replacement of the same crystal can be. Note: the crystal can not be measured, which is the best judgment method is a good substitution crystal to judge. (3) the main control, if these two conditions are normal control chip that is damaged. As long as the replacement of the main control. 2. U disk into the computer, suggesting that unrecognized equipment. Maintenance ideas: for this phenomenon, first of all show that the circuit of U disk is basically normal, but only w